Hello - I recently noticed a change to reference lines in line charts using Legend to create multiple lines –
Before: a reference line was generated for each line in the chart. I have a dozen lines, so there were also a dozen reference lines set to 80% in my case. These reference lines were stacked on top of each other. I didn’t need a dozen lines at 80%, but the look of the chart was as I desired (I could make all the lines look like a single line).
Now: only a single reference line is generated (yay!). BUT, it does not extend to the fill width of my x-axis. It’s range only matches the range of the first data series of my Legend. My full data set has data from May to October, but this alphabetically first member of the Legend happens to only have data from June to July. So, my reference line is also only extending June to July.
Can we have the reference line extend across the full range of the x-axis?